ATTO Technology UL2D Betriebsanweisung PDF herunterladen (Seite 5)

Updating UL2D Firmware on a Mac OS 9 System

4. Partition your new drives with the following:

- (Windows NT) Use the Disk Administrator included with your

Windows NT operating system.

- (Windows 2000 or Windows XP) Use the Disk Management tool

included with your Windows 2000 or Windows XP operating

system.

- (Mac OS 9 only) Use the AVIDdrive Utility 2 provided by Avid.

To use the AVIDdrive Utility 2, see the AVIDdrive Utility 2 User’s

Guide. PDF versions of the user’s guide and release notes are

included on the Avid Storage Utilities CD-ROM shipped with your

new drive.

- (Mac OS X only) Use the ExpressStripe utility provided by Avid.

This utility is installed with Macintosh Avid editing applications.

To use ExpressStripe please refer to the manual, ExpressStripe.pdf

which exists in the same location

Updating UL2D Firmware on a Mac OS 9 System

If you are attaching your new MediaDrive rS 320/LVD or MediaDock

iS 320/LVD drives to a UL2D LVD SCSI controller board in your

Macintosh system, you will need to update the SCSI board’s firmware

before the new drives can operate properly.

If your Macintosh system is a beige G3 platform, do not upgrade the

UL2D firmware to version 1.6. On the beige Macintosh G3 platform,

the latest supported UL2D firmware is version 1.45. If you update to

version 1.6 or later, your system will not boot.

You do not need to update the firmware if you are using a Windows NT,

Windows 2000, Windows XP, or Mac OS X system.

To install the EPCI firmware on a Macintosh system:

1. Quit any open applications.

2. Disable any virus protection programs running on your system.

1 2 3 4 5 6 7 8 9 10 ... 13 14

Keine Kommentare

ATTO Technology UL2D Betriebsanweisung Seite 5