ATTO Technology FC-3321 Einstellungsanleitung PDF herunterladen (Seite 12)

Fibre Channel Adapter Board Installation Notes

3. Remove the protective covers from the optical cable connector on the

optical cable.

4. Remove the protective cover from the Fibre Channel adapter board

connector on the LANserver EX system.

5. Plug the optical cable connector into one of the Fibre Channel adapter

board connectors. The optical cable connector and the Fibre Channel

adapter board connector are keyed and fit together only one way. You

should hear a click when the optical cable connector is properly seated.

Do not force the optical cable connector into the Fibre Channel

adapter board connector. There should be no resistance as you put

them together. If the optical cable connector does not fit into the Fibre

Channel adapter board connector, turn the optical cable connector

180 degrees and try to insert it again.

Running the Profiler

When you run the Profiler after installing the ATTO ExpressPCI-FC 3321

adapter board on a LANserver EX system running MediaNetwork Release

3.1.1 or earlier software, it will show a failure for the adapter board. The

Profiler does not have information about the ATTO ExpressPCI-FC 3321

adapter board, and therefore, produces a failure. The information that is

presented for the adapter board is correct.

When you run the Profiler after installing the ATTO ExpressPCI-FC 3321

adapter board on a LANserver EX system running MediaNetwork v3.2

software, it will show a pass for the adapter board.

0575101A_IN.fm Page 12 Thursday, March 13, 2003 4:13 PM

1 2 ... 7 8 9 10 11 12 13 14

Keine Kommentare

ATTO Technology FC-3321 Einstellungsanleitung Seite 12