ATTO Technology Diamond Storage Array V-Class Betriebsanleitung PDF herunterladen (Seite 97)

Hardware maintenance

CAUTIONCAUTION

Do not leave empty openings on the front or rear

of the array under any circumstances. Empty

openings affect airflow and may cause the unit to

overheat and shut down.

xhibit 9-2: Above, disk drive sled partially pulled out of the Diamond

Storage Array. Bottom left, top of disk drive sled. Bottom right, underside

of disk drive sled showing individual drives

Exhibit 9-3: The Fibre Channel or SCSI Host

Interface Card may be replaced by shutting

power down, removing any cable attached to the

port, removing the SFP according to

manufacturer's instructions, loosening the

screws at the top and bottom of the card, then

carefully pulling out the unit.

Exhibit 9-4: A power supply pulled out from a rackmount Diamond Storage Array: do not leave an empty opening

while the Diamond Storage Array is operating. Access the blower assembly and the power supply by loosening the

screws on either side of the component, then pulling out the part. If a blower or power supply stops working, keep it

in place until another component is installed. (Note: host interface configuration pictured is not supported)

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 116 117

Keine Kommentare

ATTO Technology Diamond Storage Array V-Class Betriebsanleitung Seite 97